Ultimate front spider.

Butch Lambert said:
What is the purpose of the nuts?
Click to expand...

just to help lock them in place probably not necessary but maybe just psychological.
I usually use two on each and just finger tight.
Also can make very small adjustments by tightening them slitely more on initial dial in.
 
Last edited by a moderator:
DSM said:
Sounds good...thanks. I never saw one that came plain like that...usually fully machined.
Click to expand...

It was fully machined or had the the screw holes in it and I
turned it down just past them. And skim cut each face surface, diameters and bore.
 
Zebra13 said:
Cloud,

Is the picture of a barrel set-up to chamber, or is it just staged for the photo?

Justin
Click to expand...

Yes it's being set up for chamber and thread for a savage action. In this setup I'm turning the shank down close to 1.0625 them I'll move up closer for the finish diameter and chamber and thread.
 
Last edited by a moderator:
cloudrepair said:
Yes it's being set up for chamber and thread for a savage action. In this setup I'm turning the shank down close to 1.0625 them I'll move up closer for the finish diameter and chamber and thread.
Click to expand...

Cloud,

Got it. I think your headstock needs oil!

Justin
 
Zebra13 said:
Cloud,

Got it. I think your headstock needs oil!

Justin
Click to expand...

Thanks it has a very light blue synthetic oil in it with moly.
Just a little full so it is right above the high mark when runing.
 
You must log in or register to reply here.
Back
Top