well the good news is someone heard i was looking for a rail, and another shooter called and asked that someone if he knew anyone looking for a rail!!!
bingo and i am a rail owner..not here yet. j young in blue kelbly action jewel trigger, no scope..i have a few scopes!....may start with a...
fishing!
Dave and his buddies were hanging out and planning an upcoming fishing trip. Unfortunately, he had to tell them that he couldn't go this time because his wife wouldn't let him. After a lot of teasing and name calling, Dave headed home frustrated.
The following week when Dave's...
asa.
the 80 is loaded to 2.4xx in a typical wylde chamber,,,,the length will not work in even a cutout mag, single load only for 600 yds plus,
( bill wylde helped me with my first br ar15 chamber reamer)
i say bite the bullet and buy what you like when available..i bought 10k of 205m during the shortage and paid dearly for them.
there are other primers that work
call and talk to lester bruno, he has tried a few
remember powder choice may dictate which primer is best.
i will add i just started using rl17 in a 6.5 gt ( 6gt necked up)( bigger than a dasher, smaller than 6.5x47)
al if you are using this case
wimpy me with a 130 jlk vld with bullet body above the shoulder junction
40.2 is a mere 3040
for the record we shoot late fall thru winter for our season...
BECAUSE it is the comfortable weather then...
NOT this year freezing azz cold...sorta lke winter.
we have been know to have our ac running in jan, 90,100 degree weather.
it is april and my heater is still on .
i'd blame biden but he...
so start a brush or really tight patch. mark the rod and the clocking and push the rod in one rotation and mark the rod again.. withdraw and measure the distance of one full rotation. 15 is just not an industry std
"As far as I know of, primer pocket uniformers are "only" 1 cut mill bit. They are not designed to cut on side to change the cone into a cylinder. Even using a drill press can be a PITA to correct this issue with the various uniformers I own."
being a straight end mill config they will cut the...