Search results

Possible Fix If you are using the stock Remington recoil lug you could go to one of the thicker lugs and then see where the marking is in relation to where you want it and remove the correct amount of materiel to make it so. The materiel may have to be from the lug or from the shoulder of the...

Do a search for BATF Form 1 Get this approved before you build anything. Unless you want your door busted in and your cat stomped on.

Think carbide but remember to keep cutting speeds correct A carbide end mill might help as they are more rigid but make sure your setup is tight. ie gibs snugged up a little drag induced so there is no way for anything to grab or jump when the cutter is working.

Just remembered to look up info needed Just returned from the work shop and the deltronic size I used was .2125 inch. But it has occured to me as you are looking for bushing diameter on the chamber end is the fact a lot of europen rimfire barrels are jugged, that is they are lapped bigger from...

Will look up sizes I recently threaded my CZ for a suppressor, I had to use a different set of deltronics to indicate the bore true than the deltronics that are normally used on most other 22 rimfire bores. The CZ had a smaller diameter. I will try to go look at my notes out in the work shop...

I know it would be a little bit of trouble but probably well worth it. http://www.300blktalk.com/forum/

Get a LH insert thread holding tool and turn it upside down and then thread away from the shoulder you don't want to run in to. Just make sure when you start you have enough travel for the infeed for the depth of thread that you will not run into the shoulder. HTH John

I can't believe no remarks on the barrel and bolt change over Scroll down and click on the caliber change and wait a few

http://www.remingtonmilitary.com/MSR/msr.htm#/intro ENJOY !

I have put screws into the holes when I have opened these up. I know they are a different hardness but at least it wasn't a interrupted cut and it is kinder to the carbide inserts. G'Day John aka Bungalow Bill

As I read it > Not if you are cutting and or making chips to make parts fit <

But there is another can of worms,,,,, It's called ITAR And I bet it will be used by the new change / hope govt. to kill our industry ! John aka Bungalow Bill

There is a new set of definitions ! There is two new letters defining requirements of dealer and manufacturing. These letters are ATF Ruling 2009-1 and 2009-2. I have attached them here as PDF's. HTH John aka Bungalow Bill

Fwiw "The RCBS Precision Mic is a pretty good tool, but it's quite expensive when you consider that it only works on one specific caliber. Our Digital Headspace Gauge works on almost any caliber. " Well I'm not trying to create a Urinary Olympics but my 308 case mic tells me what I want to...

Another nice tool but Not to take anything away from this newest accessory but RCBS case gages do bout the same thing and I've been using them for years.

Looking for Rem 788 scope mount, one pc prefered 308 Win cal

SB Lathe Bill, If Jim is not interested in the SB lathe you mentioned please contact me. Thank You B Bill

Moly Dee I see :) Thought it was something different or new, have been using that product for a while. Thanks

What is this Moly D ?? 200 RPM's and Moly D get me a pretty good finish. A search for this got me nothing, Who makes it, where to buy? Thanks