killswitch505
New member
Howdy from New Mexico!!! Being my first post I’ll tell y’all a bit about my self. I started chambering rifles a couple years ago when I couldn’t find a local gunsmith without a 9 month lead time. Thinking how hard could it really be I bought a lathe a mill and tens of thousands of dollars later I had my first 6.5x47L. I’ve been a lurker on this page for a couple years now the wealth of information on this page has saved my ass a time or ten so thanks y’all. My question is about power flush systems Maybe y’all could save me some time and a bit of money. I’m going through a bunch of my junk at work I found a hydraulic pump and an electric motor I think would work great for a power flush system. I can’t say I’ve seen anyone using them on this page. Why is that? I’m only doing around 10 barrels a year and things might pick up some but that’s doubtful as I’m not really pushing anything. I’m thinking I could build the system with only being out of pocket a couple hundred bucks. I’ve not had any issues chambering without a flush system. So my question is if you could build or buy one for a couple hundred bucks would you? do you think you’d actually use it if you did? Or would it be one of those tools that gets used once and never again?