Ground tool for bolt face clean up

E

eddief

Eddie Fosnaugh
I plan on grinding some HSS for the cleaning up of Rem 700 bolt faces, and was wondering if any of you guys could post some pics of the ones you have custom ground. I appreciate any responses and pics. Thanks!
 
I've posted this picture before but the tool on the right will work fine. Face from the firing pin hole out (after the extractor and ejector have been removed).

 
You can grind a bit to look like a hockey stick then you can cut the face without touching the extractor and eliminate the pain of removal and instal.

It will be quite small so that it gets under the extractor.
 
Jim S,

That's what I'm looking for. I have one in my mind, but was looking for pictures before I start grinding. If I grind it right it should reach just behind the extractor so I don't have to remove it.

Thanks for posting your pics Jerry.
 
Last edited:
You must log in or register to reply here.
Back
Top