Benchrest stock

C

charlesasmith

New member
Does anyone know of a custom stock maker that will make a benchrest for a large bottle PCP? I have a Daystate Air Wolf MCT. I have been reading Mitch's report on his FX Royale 400 stock progress. Mitch makes his own and does not know of anyone comercially providing such a stock.

Any ideas?

Thanks, Chuck
 
Chuck if you can find anyone who has Gary Lemons contact info, I know he still has one unfinished stock but for the life of me I can't remember what it is inletted for. I know it is the big bottle. There are several on here that purchased those stocks from him, Dave Shattuck being one. Maybe one of them can chime in and tell what action it is for.

Mike
 
If Gary still has any left, what it would be for is a Theoben MFR with a 400cc bottle, and I don't know just how close that would match up with your Air Wolf MCT.

Dave
 
Chuck,
I bought two stocks from Gary for my Rapids same as Dave but his stocks were for the 280 bottle. I had to buy another bottle (280) as one of my rapids had a 400 bottle. Also Gary Pillared and bedded both stocks using his Rapid. One of my Rapids fit the other wasn't even close. One action is .975 wide the other one is almost 1 inch. Had to remove his bedding and do my own.

Paul
 
Don Stith could probably make you a stock if you could send him the original so he could copy the inletting.

He is in the suppliers section on this site's homepage.
 
You must log in or register to reply here.
Back
Top