22 Stinger

J

Johle

Guest
I am looking for information on a wildcat cartridge, .22 Stinger. I beleive this rifle came from Seymour, TX possibly built by Cliff Styles.

I made a chamber casting and it measures pretty close to a Win .243 necked down to .224, approximately same body and neck taper.

Does anyone have any information about it?
 
.22 Stinger ( .224" calibre wildcats )

Johle -

Howdy !

YOu may first want to read-up on wildcats like the .224 Jaybird, and
.224 Middlestead. Also, you can check up on the 22-6mm (Rem ) or
" .22 Texas Trophy Hunter ".

I'd advise against wildcating .243 Win down to .224" calibre IF the same
parent shoulder angle were utilized. .243 Win already has a bad rep as a
" barrel burner ". By going to a smaller calibre with that 20* shoulder angler; you'd only exacerbate the barrel errosion problem.

The above mentioned wildcats can also be considered " over-bore " capacity;
when and if medium to lighter weight .224" cal bullets are shot.
Heavies like 90s may help w/ th eover-bore situation to a certain degree,
however.... 90s may not make for a good multi-use or universal-use bullet for your shooting circumstance.

I wildcatted .35 Rem down to .224" calibre and w/ a nominal 26* shoulder angle. This case capacity I found emminently sensible, and ideally usefull for my shooting needs ( live varmint and paper shoots ).

Best of luck in your endeavors.

Regards,
.357Mag
 
.224" cal wildcats 2.0

Johle -

Forgot to ask if you had ever accessed " 6mmbr.com " ?

THat's another great info source, esp on wildcat info.

Regards,
.357Mag
 
Didn't sound like he was asking for advice on creating a wildcat to me.
Sounds like he has a rifle he wants to know some history about.
 
.22 Stinger

Mike

Correct, I have a rifle chambered for the 22 Stinger. I made a chamber cast and prelimenary measurements indicate it might be a 243 necked to 224 and retaining the original shoulder.

I am hoping to contact someone who could confirm chamber dimensions.
 
Back
Top