Removing spring from ejector (BAT) action

[trasch]

Hello,

I like to know if anyone know the exact diameter for the punch to use , to remove the ejector from the bolt (BAT).
This all to remove the spring inside the bolt, to cut it so, that it throw away the cases a little closer to the rifle.
To be clear: i only need the diameter in mm's or inches, for the punch to use to remove the pin, which holds the ejector (BAT action).

Trasch

 

[Jerry W]

1/16"

Cut a half coil at a time until you get what you want. It probably won't take more than a full coil! If you go too far, it will leave the case sitting in the port.

Jerry