Dennis_in_VA
New member
I'm getting ready to put a barrel on a Bat MB and I'm ready to put the tool to the steel.
My question for those of you more experienced than myself is:
How much clearance between the bolt and the breech is necessary and how do you go about checking this to make sure that you have what you THINK you have?
How much is too much or too little gap?
Thanks in advance for your input.
My question for those of you more experienced than myself is:
How much clearance between the bolt and the breech is necessary and how do you go about checking this to make sure that you have what you THINK you have?
How much is too much or too little gap?
Thanks in advance for your input.