G
Gary L Noble
Guest
What is the optimum length of a barrel block.
Example: 30 inch 1.350 barrel on a BAT action
Example: 30 inch 1.350 barrel on a BAT action
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
The only testing I've read about was reported in the piece in the Precision Shooting article on Bruce Baer, some time ago.
As I remember, he found that a block of 8 inches or less was preferable, even on a HG.
To show that short block can work, I have a point-blank BR rifle that has a block a bit more than 3 inches -- P-B rules state that a block must end no more than 4 inches from the boltface. The barrel is glued to the block, it is a 30-BR chambering, 25-inch barrel. Works just fine.
I've seen a number of 8-inch or shorter blocks used on 1-K rifles. I currently have one on my 30-caliber LG that is 6 inches long. Tempted to go to 4 or 5 inches If I redo it.
Well, not much general information, hope it helps.
As I remember, he found that a block of 8 inches or less was preferable, even on a HG.
To show that short block can work, I have a point-blank BR rifle that has a block a bit more than 3 inches -- P-B rules state that a block must end no more than 4 inches from the boltface. The barrel is glued to the block, it is a 30-BR chambering, 25-inch barrel. Works just fine.
I've seen a number of 8-inch or shorter blocks used on 1-K rifles. I currently have one on my 30-caliber LG that is 6 inches long. Tempted to go to 4 or 5 inches If I redo it.
Well, not much general information, hope it helps.
G
gonehunting378
Guest
i would maybe like a "real" heavygun someday, so i am curious also. shooting dashers i unlikely would go with 30 or under tube.
tom
tom