Fuj's latest activity

Hi folks, I'm still around. I got dropped sometime back and I couldn't remember my password. My wife went digging for it today and found...

PM him on Accurate Shooter. He's currently in with Alnyhus (SP) on a bullet making and press conversion thread. It's a long one.....

I just cut the tension plate. The top itself needs cut to coincide for the same clearance.

I use castor oil to lube lead sticks to cut to swedge cores

I need to set up the mill for the bullet press project, but took a couple of minutes to go ahead and do a clearance slot on the right...

Castor is not talked about a lot if any but, I had several high speed punch press dies our shop had built for the older Ma' Bell...

New L-bags for the Seb - X rests look inviting. Down the road, may have to contact Biisop or Ratigan about these. Lot's of squirrels...

.Will those L-bags bags slide into the T-Rex top, or would some machining need to be done ?? They will if not filled very tight. The...

This is one of my Randolph tops that can accommodate an over 6" stock so the plate above will take these bags and side plates. It...

I have that bag holder /\ and have seriously considered cutting it in two to hold the L bags and space them as needed. This plate will...

We are pretty much on the same page. Cutting the top in half crossed my mind since It's only used for experimentation. My thoughts at...

I need to take a few more measurements, but I may have a viable plan. The first measurements does show an off set problem. This could...

I jotted down a couple of ideas some time back but got lost in the shuffle. I do know my plan was to get a hold of Protecktor and have...

It's an anti brain fart device.....My guns run at 22 lbs. and have a real good balance set up on the counter weight springs. I just swap...

I have all kinds of bag holder parts and was very close to building my own setup using a Sinclair holder and probably will yet. The...